FEX_ENABLEAVX was removed. Settings for host features should use
FEX_HOSTFEATURES but actually FEX_HOSTFEATURES=enableavx has different
behaviour, so we don't enable it.
Due to Intel dropping support for legacy segment registers[1] there is a
concern that this will break legacy 32-bit software that is doing some
magic segment register handling.
Adds some simple telemetry for 32-bit applications that when they
encounter an instruction that sets the segment register or uses a
segment register that the JIT will do a /relatively/ quick four
instruction check to see if it is not a null segment.
It's not enough to just check if the segment index is 0 or not, 32-bit
Linux software starts with non-zero segment register indexes but the LDT
for each segment index is a null-descriptor.
Once the segment address is loaded, the IR operation will do a quick
check against zero and if it /isn't/ zero then set the telemetry value.
A very minor optimization that segment registers only get checked once
per block to ensure overhead stays low.
[1] https://www.intel.com/content/www/us/en/developer/articles/technical/envisioning-future-simplified-architecture.html
- 3.6 - Restricted Subset of Segmentation
- `Bases are supported for FS, GS, GDT, IDT, LDT, and TSS
registers; the base for CS, DS, ES, and SS is ignored for 32-bit
mode, same as 64-bit mode (treated as zero).`
- 4.2.17 - MOV to Segment Register
- Will fault if SS is written (Breaking anything that writes to
SS).
- Will not fault if CS, DS, ES are written (Thus it sets the
segment but gets ignored due to 3.6).
Paulo Matos