DeeJanuz--frametop/docs/hazards.md

Potential hazards

Known ways the input changes can go wrong, and what to check when something looks off. Each has been reasoned through but not all have been seen on a headset. design.md explains why the input relay works the way it does.

Volume keys

The input relay takes the volume keys from every device that has them, so gamescope never sees one (a volume press with nothing focused aborts gamescope and ends the VR session). On devices with a keymap it remaps the volume entries to stand-in codes (KEY_MACRO29, KEY_MACRO30), and it grabs pmic_resin.

• Keymaps stay remapped if the relay dies. The keymaps go back when the relay exits normally or on systemctl stop (SIGTERM). A crash or SIGKILL skips that, and until the relay starts again the volume keys do nothing, on the headset and on any keyboard it remapped. The headset's own buttons don't reconnect, so for them only the relay coming back (or a reboot) fixes it. The relay recognizes the stand-in codes on start and takes them over again.
• The headset's other buttons share the device. gpio-keys carries the click button as well as volume. Only the volume entries are remapped, but if the click button stops working, check this first (--no-grab leaves the volume keys alone).
• The relay opens more devices than it used to. It now opens any device with volume keys, whatever its bus, not only USB and Bluetooth mice and keyboards. A device it can't remap and that has more than volume keys is left alone, and its volume keys still reach gamescope (the log says "can't take over its volume keys").
• Volume goes to the default output. wpctl steps @DEFAULT_AUDIO_SINK@ by 5%, capped at 100%. If sound plays somewhere other than the default output, the keys change the wrong one. Steam never sees the keys, so anything it did on a volume press no longer happens.
• Repeat is the relay's own. Holding a key repeats after 0.4 s, every 0.1 s, and kernel autorepeat from keyboards is ignored. If a device disconnects mid-hold, the repeat stops with it.

Key releases

ft-screens drops keys while no screen has focus or the SteamVR dashboard is open, but always lets through the release of a key the desktop saw pressed, so a modifier held as the dashboard opens doesn't stay down.

• A release that never arrives leaves the key held in the desktop. KWin repeats held keys itself, so a stuck letter repeats and a stuck modifier changes every later key (Ctrl+Alt held turns T into Konsole). Pressing and releasing the key again clears it.
• A keyboard that disconnects mid-press is one way to get there. The relay forgets the held key without telling ft-screens. The same goes for the relay restarting while a key is down.
• Switching where typing goes waits for keys to come up. The relay changes a keyboard's grab only while none of its keys are down, so a press and its release go to the same side. A key held for a long time delays the switch until it's let go.

Typing and grabbed keyboards

• Programs that watch every keyboard lose grabbed ones. While typing goes to the desktop, the relay grabs pass-through keyboards, so a hotkey tool reading them directly stops seeing their keys. SHARE_KEYS=1 in ~/.config/frametop.conf sends their keys to the abstract socket @frametop_keys instead. It's off by default: abstract sockets have no permissions, and any local process that binds the name first receives every key typed into the desktop, passwords included.
• Typing starts out going to Steam. After the desktop starts, keys go to Steam until you click a screen.
• Controller clicks don't move typing. Overlay apps don't see controller clicks on other panels, so after one typing stays where it was. A mouse click, or a click on a screen, moves it.